|
#1
|
||||
|
||||
Ansmann ARE 2 - Body Shell Question
What kind of body shells fit this car? 190 or 200mm , anybody know?
Thanks for your answer
__________________
Ansmann ARE-2 - 5.5T C4.1 Centro - 7.5T X-Factory SCX-60 - 10.5T Hyper 9e - MMM |
#2
|
||||
|
||||
std 190mm shells will fit
__________________
http://www.thercracer.com/ |
#3
|
||||
|
||||
thank you for your reply!
__________________
Ansmann ARE-2 - 5.5T C4.1 Centro - 7.5T X-Factory SCX-60 - 10.5T Hyper 9e - MMM |
#4
|
||||
|
||||
the kit wheels on the ARE-1 are a wider offset - you can use standard offset wheels but the car looks like a roman chariot going round as the driveshafts stick out for miles. the ARE-2 is pretty much the same car as the ARE-1, so if using kit wheels you will need to run a 200mm shell, if using regular wheels a 190 is fine, however i'd be tempted to fit wider hex adapaters & run the car at 200mm on standard 10th wheels or use the narrow kit hex & run regular kit wheels & the like so as not to do damage with the driveshafts that poke out the side.
|
#5
|
||||
|
||||
hello Mad-Wolfie, thank you for the feedback, will take your suggestions under advice; depending on how race-minded I get with the this onroad car, switching to regular wheels will pay off in the end;
__________________
Ansmann ARE-2 - 5.5T C4.1 Centro - 7.5T X-Factory SCX-60 - 10.5T Hyper 9e - MMM |
|
|