Go Back   oOple.com Forums > Car Talk > Team Durango

Reply
 
Thread Tools Display Modes
  #1  
Old 29-01-2014
Dino_D Dino_D is offline
Member
 
Join Date: Feb 2012
Posts: 40
Default Durango Hex Modifications

Tired of loosing those pins on your DEX210 or DEX410?
Hopefully the admin can make this a sticky or add it in the tips and tricks section.

Just made a few mods to the existing wheel hex. Thought I might share it with you guys. You just need part #704046







Test to make sure the screw sits flush in the hex or the wheel can't fit on.
You need to shorten the pin slightly so that the screws can clamp onto the hex and not protrude out. If you can't put the wheel on, either the pin is too long or the holes for the counter sink is not deep enough.




Trim any flashing so that the pin can slide in easily.



Reply With Quote
  #2  
Old 30-01-2014
D20MCK's Avatar
D20MCK D20MCK is offline
Senior Member
 
Join Date: Jun 2008
Location: Grangemouth, Scotland
Posts: 423
Send a message via MSN to D20MCK
Default

It's a good idea but not really required. All you need to do is put a small amount of the red thread lock on the pin and it won't come out or just fit alloy ones!
Reply With Quote
  #3  
Old 30-01-2014
av4625 av4625 is offline
Senior Member
 
Join Date: Aug 2011
Location: Omagh
Posts: 521
Default

i hav the alu ones and used some of the thread lock on them and it stuck them in there like super glue lol i couldnt get them out for a wile, i just try to b super careful with them now lol
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 05:51 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
oOple.com