|
#1
|
|||
|
|||
losi9500 brushless esc help!!!
i am in need of help with my losi 9500 esc!!!!! after plugging it in all i can get is full throttle and brake....there seems to be no inbetween? i acquired this as part of a buy earlier this year, i dont have the programming usb lead or connector? not sure if thats why? any help would be much appreciated.
|
#2
|
||||
|
||||
You may need to calibrate your transmitter, below is the instructions taken from my manual.
1. Turn on transmitter 2. while turning on the vehicle, press and hold the setup button ( this is on the switch), notice the yellow led is now on solid. when yellow led is on solid you can release the switch. 3. using the throttle trigger pull full throttle until green led is on solid. 4. next push the throttle trigger to full brake until the red led is on solid. 5. now return throttle to neutral position and the blue led is on solid. 6. turn off the vehicle/esc power switch. 7. turn back on, you are now ready to use. hope this helps
__________________
WWW.INSIDELINERACING.CO.UK |
#3
|
|||
|
|||
cheers for that mate will try as soon as i get home.hope it sorts it out? thanks
|
#4
|
|||
|
|||
tried calibrating and it still dont work? just noticed it is actually spinning in reverse at full throttle???? double checked the wires and there all ok.
|
#5
|
|||
|
|||
Quote:
Bye Ema |
|
|