|
#1
|
||||
|
||||
Your speedo dimensions in the 410
Hi guys,was just wondering if you know what the L/W/H of your speedo's are in your 410 and how well they fit in with the reciever in such a small space.
(My reciver is a core) The reason i ask is I've just ordered a combo and the esc dimensions are 39mm-38mm-20mm. I was wondering what the biggest is that can go in with the size of reciver I have. If this is a tight fit I'm thinking of putting my Absima cts 10 in which Is a bit smaller. I've had a look on the install pages but quite a few are running micro receivers in there's. Any info would be greatly appreciated. Phill |
#2
|
||||
|
||||
You pretty much need a micro RX in there or remove the RX box and shrink wrap it then stick it somewhere.
I have seen a RX8 in there and a reventon pro.. they are pretty large as well as a mamba max I think it was on the rctech pages, there are a few to go through there R10 fits nicely so will the CTS10 |
#3
|
|||
|
|||
If you've got a Core RC transmitter with the LCD screen, you can use this mini receiver: http://www.hobbyking.com/hobbyking/s...y_3XS_TX_.html
Works perfectly and a lot smaller than the stock receiver. |
#4
|
||||
|
||||
Quote:
Some thing like that would be great though. |
#5
|
||||
|
||||
This is the etronix that I have in my tm2 at the moment.
ET1050 Etronix Pulse EX3G 2.4GHz Receiver (CR139) |
#6
|
||||
|
||||
Hi there, I run a Speed Passion GT 2.0 LPF with a Spektrum SR301 (standard sized/quite big receiver) which I run on its side underneath the front centre driveshaft and have no problems.
|
#7
|
||||
|
||||
That's where I had my reciever in my origianal full fat 410. I had a orion vortex speedo in that and that was quite big. Think I'll wait till my combo turns up and then decide which gear to put in.
Cheers guys. |
Thread Tools | |
Display Modes | |
|
|