Go Back   oOple.com Forums > Car Talk > LRP

Reply
 
Thread Tools Display Modes
  #1  
Old 16-09-2014
Steve.T's Avatar
Steve.T Steve.T is offline
Senior Member
 
Join Date: Nov 2006
Posts: 671
Default LRP Sphere "clitching" under acceleration

I run a sphere which has developed a clich when it accelerates. I have tried resetting it and resyncing my radio gear but this has not helped.
Any advice greatly recieved
Reply With Quote
  #2  
Old 16-09-2014
mattr mattr is offline
Mad Member
 
Join Date: Mar 2011
Location: Sweden
Posts: 1,838
Default

Sensor cable.
Sensor board.
Motor wires.
That's what if be looking at in the event of glitching.
Could have a short or fault in any of them
Reply With Quote
  #3  
Old 24-09-2014
ralphee's Avatar
ralphee ralphee is offline
Mad Member
 
Join Date: May 2007
Posts: 1,049
Default

Had the same problem with a HW 2.1 XErun, no matter what i did id get a glitch under low throttle application.
In the end it turned out to be the servo/esc combination, even with a power cap it had the problem, ended up swapping out so much stuff, i bought a new esc and servo, try swapping out a lower draw servo first though!

lee
__________________
INSERT COIN
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT. The time now is 01:51 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2021, vBulletin Solutions, Inc.
oOple.com