|
||
|
 |
|
||||||||||||||||||
|
#1
16-10-2011
|
||||
|
||||
a few questions for blast users
what shims are you using and from where
and does anyone do a screw and bearing kit and if so who thanks 
|
|
#2
17-10-2011
|
||||
|
||||
|
it already come with bearings unless your after some top ceramic ones then i think some 1 will be able to supply a bearing kit, as for screws its a case of just removing and replacing with similar all though you could try look for a kit for the kyosho zx-5 as its pritty much the same car.
and ive no idea about the shims i saw a post on here that some body had shimmed some bits but never went into detail so i left mine standard
__________________
 LRP S10 Blast BX Losi Mini-T AE RC10 B3 Losi XXX kinwald edition Yokomo super dog fighter 2
|
|
#3
17-10-2011
|
||||
|
||||
|
does it hold up ok to a brushless system without shimming it
|
|
#4
17-10-2011
|
||||
|
||||
|
and if anyone can give me the size needed that would be great
|
|
#6
18-10-2011
|
||||
|
||||
|
cheers for the reply ill be redoing my diffs beforehand
|
|
#7
18-10-2011
|
||||
|
||||
|
y i left mine standard and theyve been fine, i will do them sometime ive hear 10,000 in the front and 7,000 in the back works quite well so thats were im gonna start
__________________
LRP S10 Blast BX Losi Mini-T AE RC10 B3 Losi XXX kinwald edition Yokomo super dog fighter 2
|
|
#8
18-10-2011
|
||||
|
||||
|
thats what i was told aswell and thats what ive got coming as well as the back cvds and aluminium wheel hex
|
|
#9
18-10-2011
|
||||
|
||||
|
ive not sent for the backs yet but not had a ball joint pop off suprising there quite tight on the car so just running rear dog bones still as for the aluminium wheel hex +1 a definate buy plus there suprisingly cheap for lrp also the fasttrax wheels fit very well but will break from the hex fitting after 2 meets i know mine did there very thin. i got caster sk10 wheels but some modification required to fit, losi rear wheels fit but not tried fronts.
im not keen on spoke wheels so been doing a little hunting round for dished wheels
__________________
LRP S10 Blast BX Losi Mini-T AE RC10 B3 Losi XXX kinwald edition Yokomo super dog fighter 2
|
|
#10
19-10-2011
|
||||
|
||||
|
ansmann wheels will fit too as there 12mm too
|
|
#11
19-10-2011
|
||||
|
||||
|
its not just the 12mm hex thats tells if they fit or not there like real car wheels there an offset to make sure your hub doesnt catch the wheels. the caster ones i had to cut away some of the inside fins in the wheel so it didnt catch the hub and the front need the inside lip taking down alot so it didnt catch the steering arm end
__________________
LRP S10 Blast BX Losi Mini-T AE RC10 B3 Losi XXX kinwald edition Yokomo super dog fighter 2
|
 |
|
|
LRP
Linear Mode
