|
#1
|
||||
|
||||
Morgan 3 Wheeler
Anyone one built a Mardave based one?
Anyone want to?
__________________
o0ple Trader Feedback NE Venue's New & Old my space on YouTube CFR RCTV Channel Glenn Atterton BRCA 2005 1/10th Off-Road Veterans Champion LMP12 National Champion 2003/2004 / F3 class |
#2
|
||||
|
||||
Get an existing robin reliant chassis and flip it all round.
Sounds like a horrible thing to race though lol |
#3
|
|||
|
|||
It should handle a lot better than a Reliant (that's not difficult). Have a look at videos of VSCC or VMCC racing to see what I mean. I'll have a look at building a chassis but can't do bodies. It's going to have to wait until my 1/8 stock car is sorted though.
Bob |
#4
|
|||
|
|||
steering is no issue (existing steering setup) but it is getting the power to the rear wheel that may cause the headache.
Although a modded rear pod may work, but the most accurate way would be to have the motor mounted longways, there must be something available somewhere to do this (its like a pinion but the teeth are on the face side, not the edge), or build something so the motor powers a spur gear that in turn powers the sput on the axle. the reliant is ok, but is RWD and FWS, the morgan is the opposite |
#5
|
||||
|
||||
.............
__________________
o0ple Trader Feedback NE Venue's New & Old my space on YouTube CFR RCTV Channel Glenn Atterton BRCA 2005 1/10th Off-Road Veterans Champion LMP12 National Champion 2003/2004 / F3 class |
#6
|
||||
|
||||
Morgan is rwd and fws. Its just the rear wheel is a single wheel
|
#7
|
||||
|
||||
why not use a kit front end and side car rear end?
__________________
MBModels - Schumacher Racing - Vapextech.co.uk - MRT - Savox - SMD |
#8
|
||||
|
||||
All the weight is off center also the shell wouldent look right,
|
#9
|
||||
|
||||
what about modding a tc3 drive train to drive it?
__________________
|
Thread Tools | |
Display Modes | |
|
|