hobbywing problem

[newberyclan]

can anyone help please i have a new hobbywing ezrun 60a esc and after i use the brake it wont go to full throttle gets slower then stops and flashes red wont then work until turned off then on again i have tryed changeing reciever but does the same thanks for any help.

[Hpi_guy]

Have you checked the settings and wiring?

[CrashBangWallop]

Best thing to do is the very un-manly thing of reading the instructions and setting it up to your transmitter. Just make sure your transmitter neutrals are set to neutral. Rates set to 100% etc.

[newberyclan]

yes i have done everything i can think of

[CrashBangWallop]

What radio gear are you using ? With what motor ? Cells Etc. Might give other people a shot at getting it right for you.

[Dombrasky]

Hi
green flashing meens thermal overheat
red flashing means low voltage
if battery not flat
check the voltage cutoff setting
and battery connections

[newberyclan]

Possible success i HOPE i tryed another battery it was the same so i tryed moveing the lipo cutoff from the max of 3.4v to 3.0v and it seems to be ok i ran it up and down the road for 4/5 mins with no probs could this be it ? ANY COMMENTS thanks paul ps thanks dombrasky for hopefully pointing me in the right direction

[Dombrasky]

Glad you got it sorted
it needs to be 3.0 per volt anyway as the current draw especially
when flat out can dip below 6.8 volt
:)