New Receiver Ariel

[coleman758]

Hey Guys,

A few of my receiver ariels are looking a little tatty,
My main problem is, I've snapped one. How can I go about sorting it?

Can I buy the coax type wire to replace them?

(2.4ghz by the way)

[metalmickey0]

Dead easy if you got a new bit or wire , a soldering iron and solder.
Just separate the two halves of the receiver and find where the old wire is fitted to the board. The de-solder the bit thats left and solder on the new wire. Re-assemble the reciever and jobs a good un. Oh and dont forget to unplug the soldering iron.

[bigred5765]

its a 2.4ghz coax you cant just do that they have fittings and are not soldered to the board,these should do the job
http://www.jespares.com/electric-models?page=shop.product_details&flypage=flypage.tpl&product_id=9075&category_id=506

or these
http://demonpowerproducts.co.uk/product_info.php/hpi-104085-24ghz-receiver-aerial-long-30cm-with-coaxial-plug-futabako-p-7028

[metalmickey0]

its a 2.4ghz coax you cant just do that they have fittings and are not soldered to the board,these should do the job
http://www.jespares.com/electric-models?page=shop.product_details&flypage=flypage.tpl&product_id=9075&category_id=506

or these
http://demonpowerproducts.co.uk/product_info.php/hpi-104085-24ghz-receiver-aerial-long-30cm-with-coaxial-plug-futabako-p-7028
None of my 2.4`spektrums have them, they have just a thin bit of wire same as every other reciever i`ve seen and have had. They must be a special type then thats not used much.

[coleman758]

have a look in more detail,

All 2.4ghz systems use a coax wire, Basically like what you use for TV's.
Its a twin core, So two wires basically.

Its was easy on the old 24mhz ones, That was just one wire.

Its the coax wire im having issues with.

[Big paul]

How many do you need I have a few £5 each posted.

[Ross]

have a look in more detail,

All 2.4ghz systems use a coax wire, Basically like what you use for TV's.
Its a twin core, So two wires basically.

Its was easy on the old 24mhz ones, That was just one wire.

Its the coax wire im having issues with.

Are you sure, my Sanwa uses a wire type, not coax type wire.

[Big paul]

KO Futaba use the coax type with a plug on at one end just pull the rx into two half's unplug the old one press the new one on gently with snipe nose pliers nice tight fit jobs a gooden.