Bit of help needed. X2c

[SamRCRacing]

Hi Guys,

I was just wondering if the plastic wall behind the servo is needed for support or anything. I am wanting to take it out to neaten the wires a little, mainly the servo to receiver.

Thanks,
Sam

I have attached a picture if you dont know what I am on about...

[nicVEGAchildJR]

I probably wouldn't remove the entire thing but if u need to tidy up wires just drill small hole

[metalmickey0]

I had thought about that too as same as you , servo wire has to go over it so not neat lines. I`d thought about just putting a small channel for it to sit in tho.

[SamRCRacing]

Thanks guys, I will get my dremel out and dremel out a small gap for the wires to go through...

Sam

[SamRCRacing]

This is the neatest I can get it at the moment...

[Smartalec]

Mine goes up and over without cutting anything out. Neat won't make it faster :thumbsup:

[SamRCRacing]

Neat looks nice though, it makes me mentally faster knowing it's neat! :eh?:

[Smartalec]

Fair enough :)

[Mad-Wolfie]

i suppose there will be some scientist somewhere claiming the cables being lower, reduces the centre of gravity & aids performance :D

[SamRCRacing]

i suppose there will be some scientist somewhere claiming the cables being lower, reduces the centre of gravity & aids performance :D

LOL! :woot:

[Robbiejuk]

Mine goes up and over without cutting anything out. Neat won't make it faster :thumbsup:

Mine to. I still think they put the aerial pip on the wrong side of the car though. be nice to route the motor wires down the side as opposed to diagonally across the middle.

[nicVEGAchildJR]

Mine to. I still think they put the aerial pip on the wrong side of the car though. be nice to route the motor wires down the side as opposed to diagonally across the middle.

I put my motor wires and sensor wire down between my cells