PDA

View Full Version : CAT SX3, change Servo and speedo


juergen_jl
30-07-2012, 06:23 AM
Hi,

I'm not very happy with the wiring in my SX3. The speedo on the left and the motor on the right side cause long wiring above or under the belt.....

Yesterday I reworked my CAT and got the idea to change the position of the servo from the right to the left side. sure, this requires a change of the part 3557 and 3558, too. The belt is mounted high enough, so that the servo would fit under the belt..... I am using the alloy steering, so the wrong "way round" of part 3590 could be resolved ( I hope)
Did someone already made this change? Or how did you resolve the wiring? I have seen some pics here, but could not find the topic again....
I am not frigthened, if the left-right balance will be influenced. We are talking about a few grams, This could be cleared by using sone weight.

bigred5765
30-07-2012, 10:48 AM
no need wires can be run neatly and tidily under belt lots of pics on posts on here
http://www.oople.com/forums/showthread.php?t=62362&page=15

bigred5765
30-07-2012, 10:52 AM
and here
http://www.oople.com/forums/showthread.php?t=63613&highlight=wiring