PDA

View Full Version : db-01/502X front Hex


DCM
11-05-2008, 07:18 PM
Anyone know where I can get some, I lost mine in the grass today.... and I think it got sucked into a parallel universe and vanished.

budgio
11-05-2008, 07:24 PM
Brockmodels have them

DCM
11-05-2008, 09:01 PM
top man!!

DCM
11-05-2008, 09:09 PM
Budgio, you got a PM

Guys, Brock models, not being funny, their site is unsecure.

jimmy
11-05-2008, 09:49 PM
Any losi type hexes will fit if you drill them out. I run hot bodies XX4 hexes and will soon be running AE B44 hexes (again drilled out)

DCM
11-05-2008, 09:53 PM
I was looking at the B44 ones, and am tempted by them, as I could run the B44 front wheels then!!

peetbee
11-05-2008, 10:46 PM
I was looking at the B44 ones, and am tempted by them, as I could run the B44 front wheels then!! But I run Tamiya wheels on my B44, or is it late and I'm too tired to get what you're saying?!!

AaronR
12-05-2008, 11:08 AM
Has anyone run B44 front wheels with the normal, factory 501X front wheel hex? Do they fit ok? A friend gave me a set but I have not mounted tires to them.

DCM
12-05-2008, 11:26 AM
the B44 wheels have a deeper hex, so when you tighten down the nut, they bind grr

kaszal
09-03-2011, 05:33 PM
Sorry if I'm asking an obvious question, but how should I go about drilling some AE hexes? I need to increase the internal diameter from 4.7mm to 5.0mm to fit the DB01R axles. Is it just a case of holding it in a vice and using a regular 5mm bit?

Any losi type hexes will fit if you drill them out. I run hot bodies XX4 hexes and will soon be running AE B44 hexes (again drilled out)

DCM
09-03-2011, 05:42 PM
just fit the imperial drive pins with a bit of AW grease I would of thought.