View Full Version : Neutral Creep on GTB
gordy
13-05-2008, 09:00 PM
Just wondered if anyone has had a problem with the neutral point moving on the GTB?
I keep having to bring the trim back on my transmitter after a couple of minutes of the car being run. To be honest I'm not sure if it's the transmitter or the GTB.
Just wondered if anyone else has suffered a similar problem - and whether there was a cure?
Cheers
martboy21
13-05-2008, 09:02 PM
hi mate had same problem last week,stuck car on line at regional and unexplanable it creeps forward,what radio system are you running?
markwilliamson2001
13-05-2008, 09:05 PM
Sounds like your tranny throttle trim is dodgy, or something. I would set the throttle sub-trim to neutral, then the fine trim also to neutral.
Also then reset the GTB (hold the one-touch button while switching the GTB on, then wait for the solid red light, then hit full throttle on the transmitter, then green light, full brakes, then flashing green and return to neutral on the transmitter). It should then have the red, yellow and blue lights on I think, once it has finished setting up.
HTH
Mark
martboy21
13-05-2008, 09:08 PM
i was running spektrum dx3.0 tranny and i belive the standard sr3000?(quote me if im wrong i cant remember exact model numbers!)
i just re binded the spektrum and i have had a single glitch or unexplained bust of unnormalness?
hope this helps?
gordy
13-05-2008, 09:13 PM
The transmitter I'm using at the moment is a HiTech Pro Car with a spectrum module, and a spectrum micro reciever.
Basically just wondered if this was something that happens with the GTB or whether it's more likely to be the radio? Baring in mind I've had the pro car for 4 years.
martboy21
13-05-2008, 09:21 PM
dont know the technicalities of your spektrum modules but can you re bind them?if you can just try it,apparently its quite common?(so im told)??
Chrislong
13-05-2008, 09:31 PM
If you have set the dead band to minimum, it will make the car creep forward on neutral. Basically, the minimum dead band setting gets rid of neutral.
If you are running factory settings, then im wrong, and if thats the case I think it is more likely to be your tranny.... try and borrow a tranny from a friend and set the end points to it, see if it still does it.
Chris
col300
13-05-2008, 10:07 PM
this happened to me also last few weeks. GTB been set for a good while now with same radio etc with no probs. but last couple of meetings i've had to trim the throttle back a slight bit to stop it creeping forwards!! (not changed any settings)
gordy
13-05-2008, 10:38 PM
what radio col?
col300
14-05-2008, 07:16 AM
sorry, should have said, it's just a Sanwa Gemini ii along with a Hitec receiver.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.