PDA

View Full Version : More Lipo Questions

Rich D
14-05-2008, 08:41 PM
Great idea getting Lipo questions answered so i`ll ask another.

Ive seen the Trakpower v balancer - can this be used in conjunction with a LRP Pulsar 3 ?
Chrislong
14-05-2008, 08:46 PM
Hi Rich, me again. Yes the V-balancer will work in conjunction with any Lipo charger.

+ and - from charger to input of balancer, + and - of balancer to Lipo with balance lead (one supplied suits Trakpower, others available separate) and hey presto.

You can use the Balancer as a stand alone - if you connect it to cells and not charger, it will equalise without charging.

Its very good. Gold is nice too.
Rich D
14-05-2008, 08:52 PM
Great !

This whole Lipo idea is sounding much more inviting with every post.

Can you tell me the best place to purchase a Trakpower B4 Lipo a B44 lipo and a V balancer ?

PM if needs be - thanks Chris :)
phil c
14-05-2008, 08:58 PM
so when are they going to do a lipo that fits in a s4 ? if they dont i dont want them to become legal :lol::lol:
mac
15-05-2008, 11:20 AM
Have you tried a TrakPower 3200 saddle pack in an s4?:)
super__dan
15-05-2008, 05:47 PM
How could that fit the 2+2+2 format?
Chrislong
15-05-2008, 05:59 PM
How could that fit the 2+2+2 format?

Hi James,
I don't think that would work. Have a look at the Oswestry photos and you can see Mr.Doughty's car, the rear prop shaft is too low. :(
phil c
15-05-2008, 06:44 PM
Hi James,
I don't think that would work. Have a look at the Oswestry photos and you can see Mr.Doughty's car, the rear prop shaft is too low. :(
tell me about it :thumbdown:
Cockerill
15-05-2008, 06:46 PM
What is the height between the prop and chassis of the S4?
phil c
15-05-2008, 06:49 PM
What is the height between the prop and chassis of the S4?
about three quaters of the height of a normal c cell
Garry Driffill
15-05-2008, 07:14 PM
Just looking at 2 old disasembled cells ive got here the seem to look like there the same width pointing up as across so if the chasis on the S4 was a faction wider i recon it would be possible..

http://i211.photobucket.com/albums/bb274/xx4-nutter/untitled-1.jpg

just comparing the width of 2 single cells the other way round ( across instead of facing down).
ben
15-05-2008, 07:20 PM
I think its possible to put a stick pack lipo down the left side of the chassis on the S4 chassis. If you moved the receiver to the right side. Then you would just need a way of holding it down :)
Cockerill
15-05-2008, 07:21 PM
Then you would just need a way of holding it down :)

Duct Tape :thumbsup:

What about the servo Ben :confused:
Garry Driffill
15-05-2008, 07:23 PM
Ben doesnt use a steering servo, he leaves it and takes the corner randomly :lol:
ben
15-05-2008, 07:24 PM
Duct Tape :thumbsup:

What about the servo Ben :confused:

I think me and vermin decided if it was stood up it will fit
Garry Driffill
15-05-2008, 07:26 PM
I think me and vermin decided if it was stood up it will fit

But how bad would the car handle or perform with it like that?
phil c
15-05-2008, 07:28 PM
But how bad would the car handle or perform with it like that?
cant be any worse then a pred :lol::lol:
phil c
15-05-2008, 07:28 PM
cant be any worse then a pred :lol::lol:
only joking garry :thumbsup:
Garry Driffill
15-05-2008, 07:29 PM
cant be any worse then a pred :lol::lol:......

............

only joking garry :thumbsup:



:lol: oohhww you bitch :lol:
phil c
15-05-2008, 07:30 PM
:lol: oohhww you bitch :lol:
ha ha :woot:
mardaveman
15-05-2008, 07:42 PM
Great !

This whole Lipo idea is sounding much more inviting with every post.

Can you tell me the best place to purchase a Trakpower B4 Lipo a B44 lipo and a V balancer ?

PM if needs be - thanks Chris :)
I HAVE A NEW TRAKPOWER BALLENCER FOR SALE BOXED COST ME £33 YOU CAN HAVE IT £28 POSTED