Fitting a Sintered Rotor

[Kecky]

I'm swapping the bonded rotor in my LRP Vector X11 5.5, for a sintered rotor part no.50610

Is it just a case of undoing the 3 screws, pulling the old one out, carefully putting the new one in without it picking up any debris, and putting the 3 screws back in.

[josh_smaxx]

Pretty much, just take note of all the shims and make make sure they go back in the same way they came out.

[Chris Doughty]

you pretty much have it spot on.

be careful when you get the rotors out of the packet, they have a tendancy to jump out of your hands to clunk against something metal, the magnetic power they have is immense!

[Kecky]

Thanks a lot guy's, it's nice to be reassured :D