Orca 6.5 rough noise?

[SamRCRacing]

Hi guys,

My motor was sounding sweet until when I was racing on astro it started sounding rough. So I stripped it down and gave it a quick clean but still sounding bad. Any suggestions?

Thanks,
Sam

[Dudders]

Take it apart and make sure the black magnet part is properly attached to the shaft. Mine came un glued and acted like a slipper for a few meetings, then gave up and span internally!.

Same brand and turn too :cry:

[SamRCRacing]

Just oiled bearings and still no difference, still glued but the front plate and bearing are jammed on the shaft????? :cry: I think I might just buy a new motor and give that to leggie to look at...