More speed please

[steady_eddie]

I wanted to try and increase the top speed of this set-up

Ansmann X2C
Reedy 450 ESC
Turnigy saddle lipo's 7.4v
EasyRun 4000kv 8.5T Victory Motor
20T Gear on the motor

I'm thinking the best way may be to simply put a bigger gear on the motor? Maybe a 22T or 24T or would that be no good?

This is for the Coventry Astro track with quite a long straight - the car is not slow but once upto speed you are flat out and then have to kind-of wait for the next corner, I was thinking if the car could keep accelerating it would be a bit more entertaining - not sure if it would actually reduce the lap times though.

I know people seem to use motors with less turns for more speed and those motors will have less torque but wouldn't that be the same as putting a bigger gear on a motor with more turns? Anyway I think gears would be cheaper that motors to experiment a bit.

[sosidge]

Assuming the motor is not already getting hot, then gearing up (bigger pinion or smaller spur) is the easiest way to get more speed.

I don't know the track, and you seem to be running sensorless which is a bit different to most racers, but a 20T pinion seems rather small for an 8.5 in a 2WD. Go up a tooth at a time, checking temps and performance.

[metalmickey0]

Has your esc got a `timing` or `boost` feature. If so cant you use that for the main straight. My setup has Ezrun esc and a 4300kv motor and i keep up easily with other members of our club. Just not got the skills on the bends to keep with them. Also that option is free.