king pin brace wont fit?

[newberyclan]

Hi i just bought this f2 king pin brace http://www.mardave.co.uk/example-product-3930.html and it isnt long enough its about 5mm short i have the vrx ce any ideas thanks .

[suggy007]

I do not think it is designed for the vrx ce only for the original v12

[jasond43]

its not for the ce version as it has a wide track width

[newberyclan]

is there one to fit then ??

[Rossi25rc]

No there isn't one to fit, but I called mardave and they said they mite make one.
Some people make two seprate braces to go above each wishbone. If the pin is really slack and you want to stiffen them up to stop them flapping around, I put a 2mm hole in the side of the wishbone where the pin goes through and then screw a grub screw in to hold the pin tight. That worked sweet for me. it also stiffend the front end so much i now run additive on the inside of the tire. ( tire choice may change thow)