PDA

View Full Version : LRP Sphere tc


Steve.T
02-06-2008, 12:14 PM
I run an lrp sphere tc speedo in my x5 and it has the annoying habbit of cutting out. It only semms to happen at the begining of a race and never more than twice.
I have reset several times and made sure it is on the nimh setting rather than the lipo setting but this has made no difference.
Help!!

Chris Doughty
02-06-2008, 01:24 PM
cutting out as it 'jitter' or just cutting out as in turning its self off and you have to switch it off and back on again??

Steve.T
02-06-2008, 03:15 PM
It cuts out completely for two or three seconds

Chris Doughty
02-06-2008, 04:32 PM
do you loose everything? no steering? or just throttle.

give us a complete run-down of exactly what happens and what you notice and hopefully we can give you an idea of what to do to cure it.

footey
02-06-2008, 04:44 PM
i had this problem but i just lost power and steering kept working then in the next run it was fine then round 3 it happened again:confused:

mole2k
02-06-2008, 05:07 PM
My speedo reset itself (ok i held the set button instead of the mode button while check temp :P) and it reverted to lipo mode and with the 4.5 under heavy acceleration it would cut. Turned it back to nimh mode and it worked fine. Although you say you've checked this so im not sure what the problem could be.

super sparks
02-06-2008, 05:37 PM
i had exactly the same problem returned the whole setup to my local model shop who returned it to lrp the problem was a faulty sensor in the motor,its fitted back in my zx5 and it goes like a bloody rocket

Steve.T
02-06-2008, 07:09 PM
do you loose everything? no steering? or just throttle.

give us a complete run-down of exactly what happens and what you notice and hopefully we can give you an idea of what to do to cure it.

Everything stops working but only for two or three seconds

Chris Doughty
02-06-2008, 07:36 PM
what is the rest of your equipment? are you running spektrum?

woohaa19
02-06-2008, 07:36 PM
check if any little strands on the three coloured motor wires are touching at the motor end because i had th problem your having and i just came across the problem by chance and its fine now :)

woohaa

Steve.T
03-06-2008, 08:05 PM
Thanks for the help.
Just to let you know the speedo is off to lrp to be checked
Also I use the original spectrum radio system