View Full Version : Shock tops
maineyak
23-10-2012, 02:21 PM
Does anyone do an upgraded shock top o ring of any type?
I never know how much to tighten them up. They seems to either leak or the o ring bulges out if too tight.
Thanks
mattr
23-10-2012, 02:49 PM
How can you see the oring bulging out, it's completely retained between body and cap? You sure you have it in the right place?
discostu
23-10-2012, 03:20 PM
Yeah this happens if you don't oil the I rings up what I did was take a knife and run it around the inside of the cap to create a slight chamfer on the inside the o ring has some ware to seat never had a bulge since and you can tighten all the way down.
Stu
NeilRalph77
23-10-2012, 03:47 PM
take a knife and run it around the inside of the cap to create a slight chamfer on the inside the o ring has some ware to seat never had a bulge since and you can tighten all the way down.
Stu
+1
..
hottuna
23-10-2012, 11:06 PM
Never had problems with the plastic shock caps. They don't leak, and in a big crash they rip off without ruin the housing threads = expensive
Chalkie
23-10-2012, 11:34 PM
Yeah this happens if you don't oil the I rings up what I did was take a knife and run it around the inside of the cap to create a slight chamfer on the inside the o ring has some ware to seat never had a bulge since and you can tighten all the way down.
Stu
Same here, just put a chamfer on the inside of the cap, I don't know why there isn't one to start with as the small bore shock caps come with a chamfer for the O ring moulded in :eh?:
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.