View Full Version : Pinion for TRF 501
werner1619
04-06-2008, 04:54 PM
Can anyone advise where I can find long pinions to work on my 501?
The pinions I am currently using sit on the end of the motor shaft and have lead to ruining my motor front bearing.
help.....:confused:
darryl
04-06-2008, 08:37 PM
i never had a problem running short boss pinions
GRIFF55
05-06-2008, 08:12 AM
i used tamiya pinions from brock models
AaronR
05-06-2008, 03:40 PM
I use Losi pinions.
501X Driver
06-06-2008, 01:38 PM
I have used the standard Losi and now the Robinson Alum Pro without any issue. The 1/3 of the gear does hang off the end of the motor shaft but no ill effects from it.
Good Luck
werner1619
06-06-2008, 03:21 PM
I have only had problems using the short boss pinions, have replaced 2 sets of front bearings on my LRP BL motor and it sounds bad as well, chainsaw or something...
anybody have a lead to a supplier of the long boss pinoins? I have seen Trinity version but found none on their site?
mole2k
06-06-2008, 04:03 PM
Corally do 48dp long boss pinions numbers should be #2313~#2332 / 13~32tooth. (last 2 digits is the teeth#)
http://international.corally.com/pdf/total_corally_2004.pdf
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.