PDA

View Full Version : Ceramic Balls and Circlip?


av4625
10-11-2012, 03:29 PM
What ciramic balls are people running and what circlip are you running in your ball diff? part numbers or links would be appreciated! :)

/tobys
10-11-2012, 04:21 PM
FWIW, I'm running Buds Balls and using the standard circlip (installed the correct way round with proper circlip pliers). I use the balls loose in the thrust but still use the "grooved" plates.

HTH :thumbsup:

Tom_1984
10-11-2012, 04:21 PM
I was just about to start a post like this because I am about to rebuild my diff and build a new one. Hope people reply soon :)

h0m3sy
10-11-2012, 04:44 PM
I've just built mine the same as I used to do with the Schumacher Diff. Sand the diff rings both sides, kit circlip is ok if as mentioned you install it correctly and the right way up. I didn't have ceramic balls only kit but it will do for now. Feels really good. I tightened it right up then backed it off 90*.

chet
10-11-2012, 05:43 PM
I'm with these guys standered circlip is fine just put it in the right way. There's a rounded side and a flat side. I only use it a couple times then throw it out.

Sanding the diff rings is a must or buy them sanded, and I like B-fast diff balls.

AfroP
10-11-2012, 06:37 PM
Buds balls and standard circlip

racingben
10-11-2012, 09:05 PM
I bought my durangos from the French importer on the Durango website. Their ceramic diff balls came with an upgraded c clip which so far has been fine. The original clip failed after 2 meetings.

av4625
10-11-2012, 09:22 PM
do u meen sand the plates? why? i thought people used a xray circlip or something? i dont want problems with the diff just! i did run it before but just kept slippling i had it tight enough i think the circlip slid out i heard others say this in a similar hread but cant find it!

chet
10-11-2012, 10:01 PM
do u meen sand the plates? why? i thought people used a xray circlip or something? i dont want problems with the diff just! i did run it before but just kept slippling i had it tight enough i think the circlip slid out i heard others say this in a similar hread but cant find it!


here I punched it in google for you

http://www.rcshortcourse.com/forum/hpi-blitz/22048-sand-your-ball-diff-rings-smooth-butta.html

look at he's before and after pics

there is a flat side on the circlip, I have seen many people put it in wrong and it pops out.