orion R10 problem

[delanobe]

I'm having trouble to get a linear power band on my R10 PR0 2/3S 160mah.

When using the mod software on my lrp X20 8.5 the power peaks very high at the end of the throttle. Turbo, timing etc.. is set on 0 with a level 3.
if I use the stock software and put boost, timing etc.. very low it is smooth and linear.

Any idea why this is??

[Gayo]

That's strange! Usually the R10 is really smooth, I usually use some boost and turbo to gain high end speed, and that's on a Orion 7.5.

I also believe that there is no difference between stock and mod profiles other than the possibility to add way more timing (boost + turbo) on the stock prog.

Maybe something went wrong when uploading the prog on the esc, or calibrating the radio inputs.

[delanobe]

Could you post your set up you are using with the 7.5?
Maybe I did something wrong without knowing it.

Thanks in advance!

[Gayo]

Here is my 7.5 setup, nothing special really :

Running mode : 1 (Fwd/brk)
Drag brake : 0
Low voltage cutoff : 3.2V/cell
Punch : 3
Brake force : 87.5% (Epa between 85% and 100%)
Reverse force : not revelant
Initial brake force : 0
Neutral range : narrow
Overheat protection : enabled
Boost : 10
Boost start : 5000
Boost timing : n/a
Turbo timing : 10 (15 for a long straight, 0 if slippery)
Slope : 12°/s
Turbo delay : 0.4

I'm using the latest mod software, ratio is 78/24 = 8.45
Stock timing on the motor endbell.

I tried using a bigger pinion (26) with less boost (8), power delivery is smoother but I lack some punch.

HTH

[JustARcFan]

Looks similar as my set up.

What is the latest mod software, code?

Thanks

[RogerM]

Again mine is similar.

You say that reverse force isn't relevant but it is .. try turning it up and down without changing your brake setup and see what happens!

I run reverse force of 50-75% in 2wd and 75-100% in 4wd.