PDA

View Full Version : Tapered pistons


Dan Pickard
23-02-2013, 04:59 PM
Hi, is Nick Gurnell still making tapered pistons? Cant seem to get hold of him. If not does anyone know of anyone else who is making them at the moment? Thanks

TonyM
23-02-2013, 05:29 PM
Durango tapered pistons - all with 1.0mm holes. Part numbers are:-


#TD330178 (4xholes), 330179 (5xholes) 330189 single taper(6xholes)

#TD330394 (4xholes), 330395 (5xholes) and 330396 dual taper (6xholes)

Dan Pickard
23-02-2013, 06:13 PM
yes i know, i dont want the 6 hole pistons though, and i dont want to fill in the holes and drill them myself, but thanks.

MiCk B.
23-02-2013, 06:40 PM
I've Ghea pistons.

Link: http://p-dubracing.co.uk/index.php?main_page=index&cPath=3_4&sort=20a&filter_id=3&alpha_filter_id=0

Small bore and big bore tapered pistons.

MiCk B. :-)

Tomk26B4
23-02-2013, 07:26 PM
Have a look here Dan
http://www.oople.com/forums/showthread.php?t=119273

nobby
23-02-2013, 07:27 PM
Sorry to highjack this thread, but couldn't see the point in starting another one.
I'm after some blank pistons.
Does anyone know where to get them?

chet
23-02-2013, 07:35 PM
The Ghea are 6 hole though, the pro's only run 4 hole and have started to run 2 hole now.

cornishboy176
23-02-2013, 07:46 PM
Sorry to highjack this thread, but couldn't see the point in starting another one.
I'm after some blank pistons.
Does anyone know where to get them?

PM Gixxer on here

TonyM
23-02-2013, 10:04 PM
yes i know, i dont want the 6 hole pistons though, and i dont want to fill in the holes and drill them myself, but thanks.
OK, if you want 3 or less holes then as you say, they are not for you.

Dan Pickard
24-02-2013, 10:28 AM
thanks tom