PDA

View Full Version : Set-up for Worksop with a Dimec20 chassis


brooksy
08-03-2013, 10:30 PM
Is there anybody who's run the Dimec20 chassis got a good setup for Worksop indoor masters?.

Just fitted one and was wondering if any setup changes need making to the kit one:thumbsup:

Phill

Chris Doughty
09-03-2013, 12:20 AM
My setup from the last round should be on the TD website.

I was running the DIMEC20 chassis and my car was great.

brooksy
09-03-2013, 12:56 AM
I had a look earlier Chris and both yours and Nathan's were blank,unless i was looking in the wrong place.I'll try again:thumbsup:

brooksy
09-03-2013, 01:33 AM
Tried again and it's blank Chris. So I checked Craig's from 27/1/13 and his is ok but it doesn't say if he ran the dimec or kit chassis.

Chris Doughty
09-03-2013, 09:43 AM
That's odd. Are you using iPhone or iPad to view? I heard sometimes that happens with apple devices :confused:

Fabs
09-03-2013, 09:51 AM
Are you opening it directly on your browser? On my computer if I do that, some of the sheets appear to be blank, but if I save the file on my disk and then open it with acrobat, they are filled...

brooksy
09-03-2013, 10:28 AM
Aaaah that might bit it Chris,I'm using my iPhone. Ill try later with the laptop.

Been looking at all the setups for the 210 from everybody and only Craig's show up Fabs. Ill give it a go later with the computer and see how it goes.

Thanks for the replays

Phill

brooksy
09-03-2013, 05:52 PM
All sorted:thumbsup:

danDanEFC
09-03-2013, 06:08 PM
Was it ok when you viewed them On your laptop?

I can't see them on my iPad :-(

Big E
09-03-2013, 06:42 PM
Get the adobe reader app, it will work then on the iPad.

brooksy
09-03-2013, 07:11 PM
Yep,brought it up on the laptop and it worked fine,got it straight away. All setup changes done and ready for tomorrow.:thumbsup:

danDanEFC
09-03-2013, 11:25 PM
Get the adobe reader app, it will work then on the iPad.

Sorted.

Have any of you ran on Astro Outdoors yet with the longer plastic chassis?