PDA

View Full Version : Rayspeed hubs?


sime46
17-07-2008, 07:28 PM
Just fitted some of these to my X-6. I read on Ellis's set ups that he took 2mm off the hubs where the balls screw in. He talks of washers under the ballstud, I wondered if someone can tell me the washer thickness so I can fit the right ones. Also, in order to get 4deg of antisquat, what thickness of shimz should I use. :thumbsup:

mattym0310
17-07-2008, 07:58 PM
he uses 2mm of washers so it is the same height as standard anyway, but he likes thos choice to be able to lower the balstud :)

Big E
17-07-2008, 07:59 PM
I have had my hubs lowered but to be honest I tend to always run them at the standard height.

When I say washers it is a Losi gold washer which I believe are just a touch over 1mm thick.

For 4° squat use about a 1-2mm washer.

E.

sime46
17-07-2008, 09:18 PM
Thanks very much. All gratefully received.:thumbsup:

nickhudson
18-07-2008, 07:56 AM
it seems that the rayspeed 0 deg rear hubs are always hard to get hold of - does anyone know if any shop has them in stock ?

Lee
18-07-2008, 08:12 AM
DMS had another batch of them in :thumbsup:

Darren Boyle
18-07-2008, 11:29 AM
Cheers Lee, Yep we just brought the entire last batch that came into the UK, we currently have about 15 sets in stock (only the 0 dgree ones at present, we are still waiting for the optional 1/2 degree type)

matt
18-07-2008, 11:47 AM
What ones are best for the X6 0 or 0.5:confused:

Mike Hudson
18-07-2008, 01:55 PM
depends how you want your car to feel :p most people use 0 degree i'd say though

Lee
18-07-2008, 04:56 PM
0 deg, the back end is already "locked in" enough on the X6 :thumbsup:

matt
18-07-2008, 05:45 PM
Thanks lads:thumbsup:

Swiss
28-07-2008, 09:48 AM
I purchased some of these, and fitted them to my car with std bearings and std B4 bearing spacer, (this was on my X6). Notice one of them is binding.. Not sure anyone else has encountered this?