PDA

View Full Version : Short Plastic Chassis


dpackster1980
17-03-2013, 06:05 PM
I've seen team drivers using them, the cab forward shell is available so when are TD releasing the chassis? :confused:

mihael
17-03-2013, 07:19 PM
hi there

the cab forward shell is for the +8mm plastic chassis.
there is no standard length plastic chassis.

just the dimec and the normal plastic chassis.
so all drivers drive the +8mm plastc chassis.


miahel

maky
17-03-2013, 07:23 PM
Few of the team drivers have tried a standard lenth plastic chassis . I know nathan did for couple rounds at worksop. But he used the +8 dimec20 at the last round and said it was better

av4625
17-03-2013, 08:00 PM
the standard length cab forward shell is on the TD site but not in stock so they quite possibly r makin the short chassis

dpackster1980
18-03-2013, 08:39 PM
hi there

the cab forward shell is for the +8mm plastic chassis.
there is no standard length plastic chassis.

just the dimec and the normal plastic chassis.
so all drivers drive the +8mm plastc chassis.


miahel

I was at Worksop and I can safely say that there definitely is.

AfroP
18-03-2013, 11:34 PM
lets hope the standard length plastic chassis is a lot stronger than the +8

Origineelreclamebord
19-03-2013, 08:48 AM
lets hope the standard length plastic chassis is a lot stronger than the +8

I'm assuming it's the same mould with a piece taken out in the sidepod (there should be two lines over the width of the car where the wide part starts at the front of the sidepods) - it's a lot cheaper to build such a mould for variable wheelbases, so unless they are updating the mould I don't think it will be any different. Plus, I'd think any plastic chassis from Durango currently kind of have these durability issues?

mrspeedy
19-03-2013, 03:03 PM
There's not a lot wrong with the std length alloy chassis if you ask me .. nice bit of weight low down and if you want more flex just loosen a few of the chassis screws off ... works a treat :thumbsup: