How to change KO 2123 servo case?

[Mike Hudson]

Want to change the case but can't figure out how to get the middle part of the case off? I know this has been asked before but have no idea where the threads are.
Thanks
Mike.

[mattym0310]

Sledge hammer? :D

[ashleyb4]

With reat dificulty you will have to slowly eaze it out.

A

[Mike Hudson]

With reat dificulty you will have to slowly eaze it out.

A

How do you get it to even move? i can't even get it to budge :confused::(

[ashleyb4]

Screw driver i supose try to free the inside off the case carefully.

A

[MattW]

Think i remember someone saying that to change the centre portin you need to do a bit of un-soldering. I haven't ever bothered myself - just change the outer bits!!

[niggs98]

have just done this myself as needed a new case for mine. there are 2 screws inside which make the change very difficult. i personally prized the motors section out very slowly which then gave me access to the screws on the other side but with hindsight i would of desoldered the 3 legs of the rotory switch first as this would of made the whole opperation a lot easier as then you can take the motor and board out easily and get to the 2 mentioned screws. if ya have any questions feel free to pm me