PDA

View Full Version : TRF502X Double Slipper???


94eg!
04-04-2013, 07:46 PM
After studying the instructions for the 502X, I've come to the conclusion that it might be possible to remove the BA14 pin from the 502's slipper, thereby unlocking the front outdrive/pressure-plate from the rear. I understand there is no bearing support for the BA32 shaft inside the BA31 front-outdrive, but does anybody think it's possible to simply apply some moly grease where the two parts make contact with one another?

I don't have a 502, so I cannot experiment with this idea. :\

http://i125.photobucket.com/albums/p53/94eg/rc/502slipper_zps60f9d9c6.png

hloland
04-04-2013, 09:22 PM
Yes, it is posible. This slipper is a copy of the Lazer FS slipper, were you have this option to remove the pin, and make it a double slipper. By using different slipper pads on each side of the spur gear, you can tune were it slippes first, front or rear.
52074

94eg!
05-04-2013, 05:09 AM
Cool, thanks for the confirmation. Hope I can snag one of these kits some day. :wub