speed controller repairs?

[git-r]

Hi all,

As an uncoordinated, banana fingered, blind idiot, I wired my speed controller the wrong way for a fraction of a second :(

It worked fine afterwards but after about ten mins of running it stopped sending power to the motor... All lights work and it doesn't smell burnt out.

Is there anywhere I can send it to to get it fixed? It's an Orion r10 pro and was making my xray t3 go brilliantly with a 3.5 motor before I so stupidly fried it :(

thanks in advance chaps:)

[Aire valley]

Hi.... Two guys here on Oople are highly recommended..:)
Either pugs or imull you can pm them for advice and possible repair ..
Best of luck..

[git-r]

Hi.... Two guys here on Oople are highly recommended..:)
Either pugs or imull you can pm them for advice and possible repair ..
Best of luck..

Thanks a lot for that - will drop them both a pm :)

[git-r]

Actually I got a quick response back from Orion saying it's unlikely it'll be economical to repair but to send it back and they'll take a look...
Will do this...
Wish me luck!

[imull]

See what they say, but if they want to bin it get it back and I'll take a look. Have recently repaired 2 of these that were connected backwards, if you're lucky the damage isn't too bad :D

[kartstuffer]

Can you do anything with an lap spx ,I did the same crossed power wires for a split sec and now dead but no smell .

[AfroP]

See what they say, but if they want to bin it get it back and I'll take a look. Have recently repaired 2 of these that were connected backwards, if you're lucky the damage isn't too bad :D

could i send you a novak GTB to take a look at?

[imull]

PM me with the problems and I can talk more specifically about the repair and what the problems might be :D