View Full Version : 210 diff problem?
Martin Wallace
15-08-2013, 08:05 PM
im in the middle of building the diff. followed the usual instructions etc but i find the diff halves are slopping side to side a little , the diff screw is tight, got the correct shim in it etc and ive took it apart and re-checked everything but still the same.?
Legacy555
16-08-2013, 07:38 AM
im in the middle of building the diff. followed the usual instructions etc but i find the diff halves are slopping side to side a little , the diff screw is tight, got the correct shim in it etc and ive took it apart and re-checked everything but still the same.?
I'm not sure if this will solve your problem, but its worth checking.
The internal diameter of the two thrust race washers are different - one is slightly smaller. You can see this with your eye - you don't need a calipers.
Make sure the smaller ID washer is closest to the diff bolt head.
AfroP
16-08-2013, 07:44 AM
make sure and watch the diff build video on the Durango website
it explains a whole hell of a lot more than the rubbish manual
Martin Wallace
16-08-2013, 01:02 PM
I'm not sure if this will solve your problem, but its worth checking.
The internal diameter of the two thrust race washers are different - one is slightly smaller. You can see this with your eye - you don't need a calipers.
Make sure the smaller ID washer is closest to the diff bolt head.
will do mate, and cheers.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.