Using liquid mask over Vinyl masks

[jaxx]

I have been given a body to paint for a friend and I want to make a really good job of it as the shell was not cheap.....
I have always just used liquid mask, the design i have in my head would mean a lot of cutting, so if i put small pieces if vinyl mask on then liquid mask and cut round where i need to. As i peel the liquid mask off will it peel off the vinyl?

I'll be using RCS liquid mask and RCS vinyl. Ta in advance

[Wynney]

I've done this a couple of times, it's fine. For lettering etc, I completely cover the shell in LM once the graphics are down, then cut as required. I spray on my LM through a 0.5. Needle, watered down to the consistency of milk. Gives a great smooth finish. I flash it off with a hair dryer between coats.

[eyeayen]

I've never had any problems combining vinyl and LM, it's the way to go !