View Full Version : Manual needed for FAB U4133
Dodgy Guy
12-10-2013, 11:10 PM
I don't suppose anyone knows where I can get the manual for the above?
Kurtje
13-10-2013, 03:54 AM
This would be a great help because I'm building my K1 next week!
KentH
13-10-2013, 11:37 AM
Hi.
I have the FAB im my K1. it's really nice to have.
as for the Manual i cant find any on the net, so here is the one i have at home, hope you can use it, and sorry for the bad quality, my scanner is not the best :)
Greetings from Denmark
Kent H.
richardh
13-10-2013, 11:41 AM
What are people thoughts on the FAB and what kind of surfaces are people using them on?
Dodgy Guy
13-10-2013, 06:37 PM
Hi.
I have the FAB im my K1. it's really nice to have.
as for the Manual i cant find any on the net, so here is the one i have at home, hope you can use it, and sorry for the bad quality, my scanner is not the best :)
Greetings from Denmark
Kent H.
Thanks a lot. This is a great help!
stegger
14-10-2013, 12:15 PM
Glad you've got sorted Lee. Your stuff has also been sent today ;)
Dodgy Guy
14-10-2013, 06:14 PM
Thanks Steve.
I had a problem at the weekend with the FAB. The small pin through the shaft (on the FAB adjust side) came half way out. On spinning round it shaved a groove clean through the Alloy Laymount (part number U4204).
I could see no way of tightening this pin other than tap it back into the shaft.
I ran the car for one more round and the pin has not moved but surely if it came loose before it will do it again.
Has anyone had this happen?
KentH
26-10-2013, 10:52 AM
hey Dodgy Guy.
first of all im sorry i did not mention this before!
Yes idd i have hat the same issue whit the FAB, it did the same damage to my K1 as to yous.
I did a small fix to it, and after i never have hat any problems.
It is a small ring i squeezed over the small pin so it cant move.
hope the image can help you and others.
Kent H
Denmark
Dodgy Guy
26-10-2013, 02:50 PM
hey Dodgy Guy.
first of all im sorry i did not mention this before!
Yes idd i have hat the same issue whit the FAB, it did the same damage to my K1 as to yous.
I did a small fix to it, and after i never have hat any problems.
It is a small ring i squeezed over the small pin so it cant move.
hope the image can help you and others.
Kent H
Denmark
No problem Kent.
Good idea - I will look around and see if I can come up with something similar.
Cruise
26-10-2013, 04:42 PM
The inner ring of a diff bearing is exaxtly what you need.
You may need to grind the aluminum part just a tiny bit.
Cruise
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.