Dino_D
29-01-2014, 11:44 PM
Tired of loosing those pins on your DEX210 or DEX410?
Hopefully the admin can make this a sticky or add it in the tips and tricks section. :)
Just made a few mods to the existing wheel hex. Thought I might share it with you guys. You just need part #704046
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6393
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6394
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6395
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6396
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6399
Test to make sure the screw sits flush in the hex or the wheel can't fit on.
You need to shorten the pin slightly so that the screws can clamp onto the hex and not protrude out. If you can't put the wheel on, either the pin is too long or the holes for the counter sink is not deep enough.
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6400
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6401
Trim any flashing so that the pin can slide in easily.
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6397
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6402
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6403
Hopefully the admin can make this a sticky or add it in the tips and tricks section. :)
Just made a few mods to the existing wheel hex. Thought I might share it with you guys. You just need part #704046
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6393
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6394
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6395
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6396
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6399
Test to make sure the screw sits flush in the hex or the wheel can't fit on.
You need to shorten the pin slightly so that the screws can clamp onto the hex and not protrude out. If you can't put the wheel on, either the pin is too long or the holes for the counter sink is not deep enough.
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6400
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6401
Trim any flashing so that the pin can slide in easily.
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6397
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6402
http://www.oople.com/forums/picture.php?albumid=1001&pictureid=6403