PDA

View Full Version : 511 bearing spacer help


MHeadling
14-02-2014, 04:57 PM
Getting through a build of another 511, I'm stuck sourcing these shims!

I'm after the rear drive shaft shims that go on the axle before the inner rear bering hub, BB6 part no 9804246

Also I'm after the front inner crunch spacer BE7 part no 9804303

Any help would be appreciated, or any other models of car I can use these from??

xfactor
14-02-2014, 06:30 PM
Hi Mark,

I bought these a while back. The shims for the driveshafts come in a packet of 0.1, 0.2 and 0.3 Tonys Tamiya parts do them on ebay 10 shims in each packet you get all 3 in one packet for 6.99 matey.

The crunch bearing spacer is same as kyosho :thumbsup:

Hope that helps matey.

MHeadling
14-02-2014, 06:36 PM
That's a great help!

The crush spacers, are they from the zx5, or Rb6??

xfactor
14-02-2014, 07:12 PM
Rb5 and Zx5 its what I used matey axles are same width.

xfactor
14-02-2014, 07:43 PM
Part number for shims is 53587 5mm x 0.1, 0.2 and 0.3 :thumbsup:

MHeadling
15-02-2014, 02:09 PM
Thanks for the help xfactor, I've ordered the shims up from vellrip website in Singapore, let's hope they come through quickly!