View Full Version : SX3 lipo tray dimensions
john73
29-03-2014, 05:57 PM
Could someone please let me know the outside width of a single lipo saddle tray ? :blush:
Need to check if they fit before i purchase :thumbsup:
Cheers
John
john73
30-03-2014, 12:28 AM
Are 1s lipos the same width as saddles at about 46/47 mm. I don,t have saddles yet but do have 1s ?
Need the width of the holder to make sure it will fit on the chassis and allow the Bosscat bodyshell to fit
Hoping someone can help
Cheers
Npdp72
30-03-2014, 08:20 PM
I've used a SV2 lipo tray on my ProCAT and as you can see it fits easily within the width of the original chassis. SX3 trays are a little wider but not much, should still fit fine.
Hope that helps.
john73
30-03-2014, 09:31 PM
Thanks for the reply. The problem I have is the belt is above the lower chassis on the Bosscat not like the Procat. My plan is to cut the lipo holder in half & hope is does not touch the lower belt cover.
Cheers
Npdp72
02-04-2014, 06:37 AM
I still think you will have plenty of room for saddle lipos on the Bosscat chassis.
See pic
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.