View Full Version : DEX210 -2 LRC rear toe block
A bit new to the DEX210 so sorry if this is obvious but when using the -2mm LRC rear toe block how do you maintain 0 degree kick up? Is there Also -2mm lrc FR block?
Origineelreclamebord
24-05-2014, 11:16 AM
A bit new to the DEX210 so sorry if this is obvious but when using the -2mm LRC rear toe block how do you maintain 0 degree kick up? Is there Also -2mm lrc FR block?
You don't, you get a 3 degree anti-squat with the -2 LRC block...
...unless you use the RF LRC hanger from Exotek (Link (http://www.exotekracing.com/dex210-rf-hanger-with-shims-lrc/)). I've been using it for a couple of races now, and the LRC, 0 degrees anti-squat and the V2 rear tower geometry work really awesome: The rear end seems to keep bite longer, but more importantly, it is more forgiving once it starts to lose traction :)
Of course, to test if you like the handling of the 0 degrees anti-squat you can Dremel 2mm off a plastic 0 degrees HRC hanger - it's not the most accurate solution and I think durability is questionable, but it's a cheap way to try it out before investing in new aluminium goodies.
Thanks, jut the answer i needed.
jonathan may
30-05-2014, 05:22 PM
So what anti squat should be run with the -2 lrc block ?
Origineelreclamebord
30-05-2014, 06:00 PM
So what anti squat should be run with the -2 lrc block ?
1mm height difference in either RF or RR hanger results in a 1.5 degree change in anti-squat. So whatever angle you were running before, if you switch from the 0 rear hanger to the -2mm one, you will hve 3 degrees more anti-squat.
The normal range of the DEX210 is 0 to 3, which is a good setup range. The DEX210V2 can only run 3 degrees with the standard parts.
jonathan may
31-05-2014, 09:36 AM
so if I have the 3 deg block on with the -2mm lrc block I will get 5 deg antisquat ?
Origineelreclamebord
31-05-2014, 02:33 PM
so if I have the 3 deg block on with the -2mm lrc block I will get 5 deg antisquat ?
You'll get 6 degrees - which is not within the usual setup window for 2WDs - if for any car, even...
I find the following website to be a very useful piece of reference for setups:
http://users.telenet.be/elvo/
The part about anti-squat is found at Page 4 about Suspension, and in the Setup Guide a stub and practical advice about it.
The 210 for that reason requires the 0 degree block in order to run 3 degrees, the V2 runs 3 degrees as standard and the kit doesn't contain parts to adjust the anti-squat as I mentioned before.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.