View Full Version : high front low rear hingpin height
dwp102
28-07-2014, 08:46 PM
What is the net effect of this when keeping the anti squat angle the same? In theory and from people who hqve have tried it back to back? Thanks
gazhillAE
29-07-2014, 05:51 AM
It's an Inbetween setup
Instead of running fully up for more traction or fully down for less traction and more rotation in the corners, this is a middle setting kind of an Inbetween for both!
Gaz
Andywoods
29-07-2014, 04:45 PM
It's an Inbetween setup
Instead of running fully up for more traction or fully down for less traction and more rotation in the corners, this is a middle setting kind of an Inbetween for both!
Gaz
So if both were in high position you get more rear grip? What do you run in low and high grip gaz cos ive just gone with this in between setup and not happy with it, cheers
dwp102
29-07-2014, 05:05 PM
Why arent you happy with it andy?
bigred5765
29-07-2014, 05:44 PM
It's an In between setup
Instead of running fully up for more traction or fully down for less traction and more rotation in the corners, this is a middle setting kind of an In between for both!
Gaz
if your running same anti squat as low position and run rear low and front high to get high front to same anti squat position you'll have to drop it back down to same height as running it low so this in between cant do anything as roll centre's will be in same position
bobbin
30-07-2014, 10:58 AM
read Simon moss K1 setup, that's the reasoning behind the pin placement.
http://www.petitrc.com/setup/schumacher/setupcatk1/K1_SimonMoss_Worksop20130127/
gazhillAE
31-07-2014, 07:17 AM
So if both were in high position you get more rear grip? What do you run in low and high grip gaz cos ive just gone with this in between setup and not happy with it, cheers
What don't you like ?
If you want more rotation try all bottom holes and about 2mm at rear for antisquat.
See you Sunday if you're there
danmurphy
31-07-2014, 08:23 AM
My understanding is you can run the same anti squat but alter the roll centre and centre of gravity
gazhillAE
31-07-2014, 12:07 PM
My understanding is you can run the same anti squat but alter the roll centre and centre of gravity
Yes!
Same anti squat but the washers change and go in diff places
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.