Rear Bearing Busted

[Jakes2514]

So I was replacing a worn Spur Gear on my ZX5 when I noticed my rer wheel moving allot more than usual...

I removed the rear hum and popped the shaft out to find a small ball and what looked initially like grass stuck to it.

http://i.imgur.com/c0bAapQ.jpg?1

On further inspection it became clear that I had a catastrophic failure of the inner bearing of the rear hub carrier:

http://i.imgur.com/mID2P4W.jpg?1

After some serious effort I managed to get everything out of the rear hub, however... I will need a new rear hub and also... a bearing... might take this opportunity to replace all the bearings... just in case ;)

http://i.imgur.com/BAuUCfS.jpg

[bretts]

Hi Jake

Looks like part no La244 from those pictures, set you back about £8 a pair.

Pretty standard 5x10x4mm metric bearings so getting some won't be an issue. Hub bearings take a lot of stick so replace all the rears to be on the safe side, or get a whole new bearings kit which might be cheaper in the long run.

HTH

Brett

[Jakes2514]

......

Looks like part no La244 from those pictures, set you back about £8 a pair.

Pretty standard ..... cheaper in the long run.

HTH

Brett

Thanks for the help Brett, I ordered a Complete set of Replacement Bearings (http://www.asiatees.com/display?id=44135&brand=Kyosho&model=Lazer%20ZX-5) from AsiaTees but for now will get a hub replacement bearing set from ApexModels to replace the one rear hub.

Seeing as the chassis is going on 10 years old now I think I have just been lucky in the bearing holding out for this long ;)