PDA

View Full Version : T084 Axle dimensions (Procat)


joolstacho
17-01-2015, 07:57 AM
I'm fabricating a couple of these... can't bear to pay what people are asking for them! If anyone has a spare that they can measure I'd be eternally grateful (well, that's my story anyway!) Well that should read 'silver' not 'siver'.

I need:
A: Overall length
B: length of reduced dia - I assume this is to allow the thrust bearing a little room to self-align?
C: Threaded section length.

http://imagizer.imageshack.us/v2/800x600q90/540/aAowi7.jpg (https://imageshack.com/i/f0aAowi7j)

Danf1275
18-01-2015, 03:33 PM
I'll try and remember my vernier from work tomorrow, and get one measured up for you.

joolstacho
25-01-2015, 01:08 AM
Just a little reminder on this one, measurements please.
Jools

SlowOne
25-01-2015, 03:36 PM
You could buy the one I have and measure it if you like!! :D :D

joolstacho
27-01-2015, 08:02 AM
SlowOne I wouldn't mind that if the cost is reasonable. The most recent I've seen for sale is not cheap, but worse, they want 30 bucks to post it to OZ (I'd be amazed if it actually cost more than 10 bucks to send).

Danf1275
27-01-2015, 09:29 PM
Apologies for delay - a lot going on at home and work at the moment,

A = 39.5mm
B = 4mm
C = 9mm

Note that there is a small shoulder before section B, about 1.2mm long and same diameter as main shank, to centre the spring washers, 4mm length includes this.

Cheers,

Dan

joolstacho
28-01-2015, 09:12 AM
Brilliant Dan, now I can make one or two.