PDA

View Full Version : Dex210v2 gearbox bind.


Stevebolt
19-01-2015, 06:31 PM
Got a few gearboxes with a slight bind , tried various combinations but can't narrow it down . Ball diff or geared diff makes no difference , gearbox casings maybe one explanation . Was wondering if anyone has had the same problem , and sorted it . I have four gearboxes with the bind.

madap1
19-01-2015, 06:54 PM
Is this a brand new car?

Mine used to bind when the small bearing needed replacing. And dont over tighten the gearbox screws. Just a tiny nip is enough

Stevebolt
19-01-2015, 07:10 PM
Both cars from new about 6 month old now , with spare gearboxes ball diff and geared diff . I've tried it with diff out then lay shaft out but same , I'm careful not to over tighten . Seems it's the idle gears , only noticed it recently so might of done it from new.

av4625
20-01-2015, 12:51 AM
the screws dont need to be tight at all on the 210 gearbox, im the sorta guy the tightens everything down really well but you really do have to go easy on the 2 screws that hold it together and the 3 long ones that go onto the motor mounting plate, every time i rebuild the car it feels like it binds a little as the layshaft isnt supported properly until the car is all back together and then its free again, so once its back i the car and every things back together it shouldnt be to bad and if it still has a slight notch after a run it should be fine!

Stevebolt
20-01-2015, 07:16 AM
I'm going to have another look at them this week , one has started to sound noisy . Also I'll be switching back to ball diff soon .

av4625
20-01-2015, 11:26 PM
Make sure the tiny bearing in the gearbox is ok, the one that the layshaft sits on!