View Full Version : Wiring KO PS1001 Servo
J'MM'N
23-07-2015, 11:04 PM
I have a KO servo which has the separate power supply lead and in the old days we used to wire this direct to a tail coming of the esc.
Can anyone tell me where I can wire this too, on a modern brushless setup?
Northy
24-07-2015, 07:40 AM
Just connect it to the +ve battery terminal.
G
DerbyDan
24-07-2015, 08:16 AM
^^^What he said^^^:thumbsup:
Just make sure you solder in an in-line choke to stop any glitching (although now less critical with brushless motors)
J'MM'N
24-07-2015, 11:10 AM
Thanks guys:) thought that would be the case, just wanted to play safe. Think I've still got some chokes.
dodgydiy
24-07-2015, 08:38 PM
i am still using a couple of 1001's, they have been fine with lipo. as said above, wire straight to live through a choke. with a ko ps87 i also run a 0.1 ohm resistor before the choke just to make sure currents dont go too high for the old fets.
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.