View Full Version : Alloy servo horn for kf2
dibble34
26-07-2015, 06:44 PM
Hi all
Can anyone recommend a good alloy horn that fits the kf2? I have tried the core RC clamping one and killed that by rounding off the teeth in a small crash :blush:
It's 23t if that makes a difference
Cheers
Dave
danmurphy
26-07-2015, 07:17 PM
Answer RC small servo horns are a perfect fit :thumbsup:
Answer RC small servo horns are a perfect fit :thumbsup:
Plus one for this, make sure it's the small one though.
Out of interest I've had the Core for a while with no issues, surely it's better to do the servo horn and not the servo ?
dibble34
27-07-2015, 06:20 AM
Cheers guys.
Ross I did it on the first run in the wet. Think I have a small answer RC, but the fit is so tight I couldn't get it on my ko servo. Maybe I should have another go.... I have spare plastic gears for the servo...
Cheers guys.
Ross I did it on the first run in the wet. Think I have a small answer RC, but the fit is so tight I couldn't get it on my ko servo. Maybe I should have another go.... I have spare plastic gears for the servo...
I found the large answer one a tight fit but the small was good lol.
fivepointnine
28-07-2015, 05:32 AM
I have always used the shorter Core clamping arm on all the Schumachers I have had, never had an issue. The long one requires a little bit of filing on the end to avoid rubbing on the bottom plate.
danmurphy
28-07-2015, 06:20 AM
I've also had the core rc one jump the splines. I've just bought another answer rc small horn for a new KO servo and couldn't get it to fit, not just me then?
Ritchie T
29-07-2015, 01:42 AM
Replacing servo gear sets instead is cheap & fun :eh?:
Replacing servo gear sets instead is cheap & fun :eh?:
Said nobody ever.......:thumbsup:
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.