View Full Version : Kf bulkhead
Stevebolt
27-09-2015, 10:30 PM
Got a couple of kf's with striped shock tower fixings on the bulkhead , any cheeky fixes for this or is it new bulkheads .
wingers
27-09-2015, 10:57 PM
I've seen some with the back of the boss removed with a dremel and a nut fitted behind the plastic instead.
Not sure if it would be as strong but it might be an option...
Wingers
andy-aj
28-09-2015, 07:15 AM
Pilot drill, 2.5mm, though the hole and out other side at the same angle as the hole in the bulkhead. Then screw in a M3 20-25mm set screw until there is only 10mm sticking out the front. Push the tower and shock guard on, and secure with a couple of washers and nyloc nuts.
Stevebolt
28-09-2015, 05:16 PM
Pilot drill, 2.5mm, though the hole and out other side at the same angle as the hole in the bulkhead. Then screw in a M3 20-25mm set screw until there is only 10mm sticking out the front. Push the tower and shock guard on, and secure with a couple of washers and nyloc nuts.
Could you point me in the direction of the set screw please.
Dombrasky
28-09-2015, 05:30 PM
If you cant get set screws and you have a dremel,use a cap head bolt
put a nut on first so it cleans the threads after..then.cut the head off
the bolt,i used some red threadlock so the stud doesn't undo itself
when you undo the nut..works a treat :)
Got a couple of kf's with striped shock tower fixings on the bulkhead , any cheeky fixes for this or is it new bulkheads .
You could try this :)
http://www.oople.com/forums/showthread.php?t=146964
Stevebolt
28-09-2015, 08:44 PM
Cheers guys , like it .
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.