View Full Version : b44 shocks on a durga: will they fit?
cjm_2008
17-01-2009, 02:11 PM
I'm about to start building my durga.
the kit shocks look a bit.... crap :lol:
fortunately, the fully assembled spare set I had left over after selling my b44 are still sat in the same box they've been sat in since august. so i'm thinking of whacking them on.
I also discovered an unused set of jconcepts rims I had totally forgotten about - bonus!
has anyone else tried this? are they an appropriate length?
thankyouta.
dry build the kit shocks, measure them up against each other dude.
JConcepts, if they are BJ4 should, if they are B44, will need the deeper hex.
Mike Hudson
17-01-2009, 02:22 PM
associated shocks should be fine on it, I seen a few people that run them on their durgas :D
cjm_2008
17-01-2009, 09:16 PM
:thumbsup: started building it tonight!
it's been a long time since I last built a tamiya buggy (1992 - super astute).
they seem to have really gotten their act together. luckily the slipper clutch and 3 racing titanium screw set arrived this morning. I can't imagine how much of a pain in the ar$e it would have been to try assembly using the kit philips screws...
I've got the motor plate in place, and the diffs built. luckily I found tons of tips on diff assembly, and put it together the right way round :D
peetbee
18-01-2009, 01:16 AM
I put associated shocks on mine Craig and they seemed to fit ok, although maybe better with a limiter on the rear as they were a fraction too long.
Crazy L
19-01-2009, 07:05 PM
I have AE FT B4 shocks on mine, no probs, didn't bother with a limiter though, seemed ok as they are.
Much better than the dire items in the kit, they're even worse than the bright yellow ones you used to get.
cjm_2008
19-01-2009, 10:32 PM
well I've ordered what i think are the correct (team associated) mounting bushings for the shocks - then it's just a case of fitting them and finding a good baseline setting to work from. I've got plenty of time to put it all together, so I can get everything bang on :D
Eddie168
13-03-2009, 12:09 AM
I have a set of B4 shocks and ready to put on my Durga anad just wanna know what size of limiter should i use for front and rear shocks?? thx
Mike Hudson
13-03-2009, 11:01 AM
the fronts should be fine with no limiters i think but the rears may need 2 or 3 1mm limiters in
Fat Corgi
02-03-2010, 08:59 PM
For those that are running the B44 Dampers on a DB01, how did you mount them to the stock suspension towers? Obviously the dampers don't fit the stock DB01 5mm balls, so what have people come up with?
Thanks
peetbee
02-03-2010, 11:00 PM
I just screwed the appropriate length bolt straight into the tower from in front of the shock and it's been fine.
94eg!
02-03-2010, 11:55 PM
For those that are running the B44 Dampers on a DB01, how did you mount them to the stock suspension towers? Obviously the dampers don't fit the stock DB01 5mm balls, so what have people come up with?
Thanks
You need the AE plastic upper mount bushings. They are just like the 501X ones. Those will probably work too...
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.