Hobby wing xr10 pro v4 esc how to calm the beast

[Rstephenson]

Hi folks as above I have not long got a hobby wing xr10pro v4 with programmer
I have set it on modified and turned boost down and turbo both to 0 and on my motor I have set it to 0 timing . As soon as I am going around corners and slowly put the throttle on it seams to kick in boost so I'm then fighting with it

[Chris Larner]

Could be the way you have set it up initially or how you have your transmitter setup.

[Rstephenson]

Hi thanks for the reply . Not that I could tell I have every thing set as neutral . I run 2 other cars from remote and work fine I used to have a reedy black box in it and worked fine 😩 I'm sure it's an easy fix but it's so aggressive on minimal throttle

[Rstephenson]

It's just like your slowing for a corner and just as u start to give I little gas it runs away like a boost has kicked in. I understand it's not easy without seeing it nor transmitter

[Coastal]

I would guess with out seeing your settings the throttle control is set too high try reducing the number as a higher number gives more punch.
Also look at the PWM Drive frequency a lower number will make the car more punchier.
Check you have no throttle expo and your end point's on the transmitter are set to 100%