View Full Version : Gearing for an Ansmann Clash 15?
cloakable
04-02-2009, 06:02 PM
Got one of these little beauties, and I'm wondering what pinion I should stick in it - the 18T in there before got fairly hot with the kit pinion, so i reckon a 15T would cook with the same!
qatmix
04-02-2009, 08:31 PM
I had one of these 15t motors and they were not really very powerful (even in my lightweight TC). What car are you running it in?
cloakable
05-02-2009, 01:55 AM
I'm going to be running it in a DB01
qatmix
05-02-2009, 01:46 PM
It doesnt have much Torque so I would look at the ratio you want to run it at and then if you dont think the motor is getting up to speed, replace it with a smaller pinion.
If you are running it outside and bashing, it may be ok as the motor has much longer to get up to speed.
Infact tonight I might put my old 15t in my tamiya voltec and see what happens when I raace the TC's
cloakable
05-02-2009, 09:55 PM
Any ideas of what motor I would want with a balance between speed/torque, with a slight favouring of torque? Non-brushless at the moment, I can't afford that kind of money just now :)
cloakable
20-02-2009, 02:57 PM
Well, another cheap £7 motor melted, I'm looking for something a little nicer. I'm thinking of getting a LRP GT3 Turbo 17x2 and running it with a 21 tooth pinion, stock spur gear. Good idea?
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.