XXX G+ Help!

[Ivan]

I love the XXXG+, my dilema is that i am running the Novak 3.5R but i cant seem to get the body to fit right, it appears that the motor with wiring is just slightly too big to sit right, grant it i have cut the long wires on the actual motor and made them shorter and still cant get it to sit correct everything is tidy, but the damn body has a small indentation and just cant sit correct, does anyone make a slightly better fitting body for it, i dont race i just run the car when i am bored or finish flying, i am waiting for my BJ4WE and plan to run the same motor combo but i am hoping that i dont have the same problem...Ivan!

[XXXCRRacer]

Well yo might have to cut the body to make the motor fit.

[Ivan]

Ok thanks!

[super__dan]

That may well make it illegal depending on where you race.

[barnyard]

figure out exactly where the shell catches, heat the shell up in that area and re model the shape.

At the euros last year a lot of the xx4 drivers had to mould a bump into the shell to clear the brushless speedos with fans fitted to the heatsink. In most cases this was done using a lighter and the handle end of a screwdriver (dont use fingers).

Do the adjustments in small steps and dont get the shell too hot otherwise you'll break thru.