View Full Version : Raising Knuckle Arm 22-4 Question
dibble34
28-08-2017, 09:04 PM
Hi all
I see on a lot of setups the knuckle is raised by 2mm. Is this done by shaving 2mm off the bottom of the caster block? Also am I right In thinking people flatten the camber link on the caster block?
Cheers
Dave
/tobys
28-08-2017, 09:16 PM
Its done by taking 2mm from the bottom of the steering knuckle. You can do it with the plastic ones but I have snapped one so have done the same trick with the alloy knuckles. It can be done with a dremel and a steady hand.
Yes, flattening the camber mount position on the caster block is also commonly done.
dibble34
29-08-2017, 05:27 PM
Thanks for confirming. Look here though http://site.petitrc.com/setup/losi/setuptwentytwofour/224_TechTips/
Looks to me like they are shaving 2mm off the bottom of the caster block to achieve the same affect?
/tobys
29-08-2017, 07:56 PM
yes i guess that would do the same.
here's what I've done.
dibble34
29-08-2017, 08:06 PM
That does look very smart :thumbsup:
/tobys
30-08-2017, 06:41 AM
Just seen this which details the operation but removing material from the caster block, as per your earlier link.
http://losiracing.blogspot.co.uk/2017/08/tlr-22-4-20-front-spindle-height.html?m=1
dibble34
30-08-2017, 06:58 AM
Interesting about the shock changes too, cheers
/tobys
30-08-2017, 11:46 AM
Also take a look on that site for flattening/removing tweak from the rear shock tower. It's a pretty good resource and well maintained :thumbsup:
dibble34
30-08-2017, 09:32 PM
Will have a read, thanks for your help :thumbsup:
vBulletin® v3.8.7, Copyright ©2000-2026, vBulletin Solutions, Inc.