PDA

View Full Version : X6 Eden Park setup


Team No Idea
07-04-2009, 01:22 PM
Hello, im looking for a bit of setup info for my new spangly X-6.
I'm fairly green to 2wd and i went up Eden park for a run around.
The car felt very "safe" but had massive understeer and was prone to bottoming out.

Im looking for a base setup from anyone please that i can work from.
Also running AE shocks, i know everyone is running LOSI but im rapidly running out of funds to buy new stuff.


Any help would be fandoobles!!!
Thanks:thumbsup:

millzy
07-04-2009, 01:24 PM
have a look on this

Ellis and Matt both post set ups

http://www.oople.com/forums/showthread.php?t=21269

Body Paint
07-04-2009, 01:56 PM
Hello, im looking for a bit of setup info for my new spangly X-6.
I'm fairly green to 2wd and i went up Eden park for a run around.
The car felt very "safe" but had massive understeer and was prone to bottoming out.

Im looking for a base setup from anyone please that i can work from.
Also running AE shocks, i know everyone is running LOSI but im rapidly running out of funds to buy new stuff.


Any help would be fandoobles!!!
Thanks:thumbsup:

Sounds like the rear end was either to low or very soft. I always run mine with the driveshafts very slightly above level, or as some call it, slightly sad :(. The car does tend to look a little high, but it works really well.

There are a few rough conversions between AE pistons/springs and Losi about (though I don't know the URLs)

I think #2 associated is similar to red losi piston and silver rear associated spring is similar to pink rear losi spring.

Also, if the grip is high I always run the middle hole on the rear wishbone which would give a little more steering and also might help stop your bottoming out (don't forget adjust the ride height after moving shock positions)

Al3xis007
07-04-2009, 04:35 PM
you can use losi pistons in ae shocks if you're tight for money :thumbsup:

there should be a set up sheet for ae shocks included with the kit from paul sinclair and ellis stafford

Team No Idea
07-04-2009, 05:25 PM
Exellent, thanks very much, that gives me something to work with:thumbsup: